Gardyn Studio, Step 4: Attach the Light Bar & Upper Blade

Your light bar's bulb plastic may be loose and/or arrive with tape on it. Remove the tape if present. If needed, slide the bulb plastic back into the bar from the top or bottom until it aligns with either end of the white LED strip. Camera cover or camera popped off? Learn how to easily put them back into place here.

Hold the light vertically so that the camera is near the top. Carefully yet firmly slide the bottom of the light onto the lower blade attached to the lid.

Align the parts, press the pin, and slide it in until you see the grey post in the notch of the light bar. Don't forget to remove the camera's protective film!

If you need to unplug the light bar, make sure your device is powered off. Simply press the pin and gently slide the light vertically until it releases.

Insert the metal rod onto the back of the columns, then slide the metal plates into each column and insert 2 plugs to secure.

Next, attach the upper blade by carefully sliding it into the light first, then clip it onto the metal rod. Press firmly to ensure the upper blade and metal rod are fully connected.

Gently slide the light protective cap down until it's flush with the light bar.

Finally, attach your Gardyn to the wall using the 2 safety straps in the back. Screw directly into a wood stud when available. In the absence of a stud, use the appropriate anchor and screw for your wall type.

Questions? Email us at support@mygardyn.com